China Wholesale Power Supply Pcb Board Pricelist - 6 Layer ENIG Heavy Copper PCB – Huihe

Crack problem of inner thick brazing pad

The demand for heavy copper PCB is increasing, and the inner layer pads are getting smaller and smaller. The problem of pad cracking often occurs during PCB drilling (mainly for large holes above 2.5mm).

There is little room for improvement in the material aspect of this kind of problem. The traditional improvement method is to increase the pad, increase the peeling strength of the material, and reduce the drilling rate, etc.

Based on the analysis of PCB processing design and technology, the improvement plan is put forward: copper cutting treatment (when etching the inner layer of the solder pad, the concentric circles smaller than the aperture are etched) is carried out to reduce the pulling force of copper during drilling.

Drilling a drill hole that is 1.0mm smaller than the required aperture, and then carry out normal aperture drilling (secondary drilling) to solve the crack problem of inner thickness brazing pad.

Applications of the heavy copper PCB

Heavy copper PCB is used for a variety of purposes, e.g. in flat transformers, heat transmission, high power dispersion, control converters, etc. In PC, automotive, military and mechanical control. A large number of copper PCBs are also used:

Power supply and control converter

Welding tools or equipment

The automobile industry

Solar panel manufacturers, etc

Equipment display

Automatic Plating Line

PTH line

LDI

CCD Exposure Machine

Our factory